Pioneer Model SA9100 Integrated Amplifier
|
Please feel free to copy and paste the following HTML code to link to this specific page in auctions or from your web pages: <a href="http://www.classic-audio.com/pioneer/SA-9100.html">Pioneer Model SA9100 Details Page <i>on www.classic-audio.com</i></a>
It will look like this on your auction or page: Pioneer Model SA9100 Details Page on www.classic-audio.com
Visitors to your auction or page can click on it, and they'll be taken right to this web page!
|
|
|
|
Front view
EBay Auction #1375077874
Image Attribution: jfriese@mindspring.com
Date: September, 2002
|
|
| General |
| Description | Integrated Amp |
| Designed in | Japan |
| Manufactured In | Japan |
| Matching Tuners | TX-9100 |
| Wood Case | Yes |
| Channels | Two |
| Transistor Count | 63 |
| Diode Count | 30 |
| Speaker Connections | Three sets |
| Chassis Ground | Two knurled screws |
| AC Switch | Yes |
| Fusing | 5A/125v external buss |
| Switched AC Outlets | One 150 watt |
| Unswitched AC Outlets | Two, 250 watts total max |
| Power Consumption | 400 watts max |
|
| Physical |
| Panel Width | 16 15/16ths |
| Panel Height | 5 7/16ths |
| Depth | 13 7/16ths |
| Weight | 29 lb, 15 oz |
|
| Amplifier |
| RMS Power Per Channel | 60/8 ohms, 75 4/ohms |
| Damping Factor @ Load Impedance | 70 or above |
| Total Harmonic Distortion (THD) | 0.1% at full power, below .04% at 1 watt |
| Power Bandwidth | 5 Hz to 40 KHz |
| Frequency Response | 7 Hz to 80 KHz, +/- 1 dB |
| Hum and Noise | < .001 Volt (0.13 uW) |
| Signal to Noise Ratio | 90 dB at tuner or aux |
| Intermodulation Distortion (IM) | 0.1% at full power, below .04% at 1 watt |
| Input Impedance | 50 k-Ohm |
| Input Sensitivity for Full Output | 500 mV |
|
| Preamplifier |
| THD | 0.03% |
| Multiple Bass Adjustments | 50 Hz, 100 Hz |
| Multiple Treble Adjustments | 10 kHz, 20 kHz |
| Tone Control Defeat | Yes |
| High Filter | 12 KHz or 8 KHz |
| Low Filter | 8 Hz or 30 Hz |
| Gain Control | Yes, with mechanical preset |
| Loudness Contour | Yes |
| Mono | L, R, L+R |
| Muting | -20 dB |
| Channel Reverse | Yes |
| Balance | Yes |
| Number of Tape Monitors | Two |
| Tape to Tape Dubbing | Yes |
| Auxillary Input Source | Yes, independent level control on rear deck |
| 2nd Auxillary Input Source | Yes |
| Phono Input Source | Yes |
| 2nd Phono Input Source | Yes, independent level control on rear deck |
| 2nd Phono Pickup Impedance Control | 100k, 50k, 25k - rear deck access |
| Tuner Source Input | Yes |
| Source Microphone Input | Yes, left |
| Source Microphone Input 2 | Yes, right |
| Tape Monitor | Yes |
| 2nd Tape monitor | Yes |
| DIN Recorder Jack(s) | Tape 2 only |
| Preamp to Amplifier Jumper(s) | Yes |
| Headphone Jack(s) | Yes |
| Speaker Selection Nomenclature | A, B, C |
| Signal to Noise Ratio | 90 dB at aux and Tuner |
| Rated Output Level | 2 Volts |
| Maxiimum Output Level | 2 Volts |
| Output Impedance | 8 ohms |
|
Have some additional information about the Model SA-9100 Integrated Amplifier? If so, I would sure appreciate it
if you would EMAIL
that to me. I'll add anything: What type of controls, specifications, number and type of AC outlets on the back...
anything!
One thing, though... if you see some info and you believe it is incorrect, that is certainly
possible. However, it does no good to tell me that "I don't think that's right".
You need to tell me the correct information to replace it with. For instance, if I have that
a particular model was available 1978-1979, and you believe that is wrong, then tell me the
exact correct range and your source of information, rather than "I had one of those in 1976". Otherwise, I can't
really change the database with any confidence.
The database currently contains "slots" for many AM Tuner, FM Tuner, Amplifier and Preamplifier specifications,
as well as many of the controls and features Pioneer has made available on these units. You can check the Sample Unit to see all of the database slots. You
might even be surprised at some of the slots that are available. However, if you come up with something that's not in the Pioneer Classics database, either a specification
or a feature, I can add it in just a few minutes, along with specific details about that feature for any model(s) you know of. Don't be shy - tell me!
These listings can only be as good as the information in them. With your help, they will improve over time. Please accept
my heartfelt thanks in advance for anything you can contribute.
Click to Return to the Master Indexes
