Technics Model SU-8600 Integrated Amplifier
|
Please feel free to copy and paste the following HTML code to link to this specific page in auctions or from your web pages: <a href="http://www.classic-audio.com/technics/SU-8600.html">Technics Model SU-8600 Details Page <i>on www.classic-audio.com</i></a>
It will look like this on your auction or page: Technics Model SU-8600 Details Page on www.classic-audio.com
Visitors to your auction or page can click on it, and they'll be taken right to this web page!
|
|
|
|
Front view
Image Attribution: Technics Brochure
Date: October 28th, 2001
|
Interior view
Image Attribution: EBay seller "panther"
Date: November 4th, 2001
|
Rear View
Image Attribution: EBay seller "panther"
Date: November 4th, 2001
|
|
| General |
| Description | Integrated Amplifier |
| Rarity | X-Rare |
| Designed in | Japan |
| Manufactured In | Japan |
| Matching Tuners | ST-8600 |
| Wood Case | Yes |
| Speaker Connections | Two Sets |
| Speaker Fusing | On rear deck |
| Chassis Ground | Knurled screw |
| AC Switch | Yes |
| Switched AC Outlets | One |
| Unswitched AC Outlets | One |
| Power Source Details | Single standard transformer |
|
| Physical |
| Width | 19 9/32nds inches |
| Height | 7 3/32nds inches |
| Depth | 13 3/8ths inches |
|
| Amplifier |
| RMS Power Per Channel | 73 watts |
| Damping Factor @ Load Impedance | 50 |
| Total Harmonic Distortion (THD) | 0.08% (0.02% at 1/2 power) |
| Power Bandwidth | 20 Hz to 20 kHz |
| Frequency Response | 20 Hz to 20 kHz |
| Hum and Noise | 92 dB |
| Signal to Noise Ratio | 92 dB |
| Intermodulation Distortion (IM) | 0.08% (0.02% at 1/2 power) |
| Input Impedance | 47 k-Ohm at aux |
| Input Sensitivity for Full Output | 150 mv at aux |
| Heat Sink Details | Internal, finned vertical monolithic |
|
| Preamplifier |
| Bass Turnover Options | 250 or 500 Hz |
| Treble Turnover Options | 2.5 or 5 kHz |
| High Filter | 12 dB/octave |
| Low Filter | 12 dB/octave |
| Gain Control | 26-step attenuator type |
| Loudness Contour | Yes |
| Mono | Yes |
| Muting | -20 dB |
| Channel Reverse | Yes |
| Balance | Linear |
| Number of Tape Monitors | Two |
| Tape to Tape Dubbing | yes, 1,2 or 1,2 |
| Auxillary Input Source | Yes |
| Phono Input Source | Yes |
| 2nd Phono Input Source | Yes |
| Tuner Source Input | Yes |
| Headphone Jack(s) | Yes |
| Speaker Selection Nomenclature | Main, Remote |
|
Have some additional information about the Model SU-8600 Integrated Amplifier? If so, I would sure appreciate it
if you would EMAIL
that to me. I'll add anything: What type of controls, specifications, number and type of AC outlets on the back...
anything!
One thing, though... if you see some info and you believe it is incorrect, that is certainly
possible. However, it does no good to tell me that "I don't think that's right".
You need to tell me the correct information to replace it with. For instance, if I have that
a particular model was available 1978-1979, and you believe that is wrong, then tell me the
exact correct range and your source of information, rather than "I had one of those in 1976". Otherwise, I can't
really change the database with any confidence.
The database currently contains "slots" for many AM Tuner, FM Tuner, Amplifier and Preamplifier specifications,
as well as many of the controls and features Technics has made available on these units. You can check the Sample Unit to see all of the database slots. You
might even be surprised at some of the slots that are available. However, if you come up with something that's not in the Technics Classics database, either a specification
or a feature, I can add it in just a few minutes, along with specific details about that feature for any model(s) you know of. Don't be shy - tell me!
These listings can only be as good as the information in them. With your help, they will improve over time. Please accept
my heartfelt thanks in advance for anything you can contribute.
Click to Return to the Master Indexes
